How to add and reset Aurora products on Hubitat Elevation hub

Authored by: Support.com Tech Pro Team

1. Introduction

How to add and reset Aurora products on Hubitat Elevation hub

2. Resolution

AOne Smart Remote

Product Number

Device Type

Protocol

AU-A1ZBRC

Button Controller

Zigbee

Factory Reset

1. Remove the battery cover.
2. Press and hold the pairing button for 3 seconds before releasing.

Join the Zigbee Network

1. Remove the battery cover.
2. From the Hubitat Web Interface home page, select Zigbee on the Device Discovery page to start device discovery.
3. Press and hold the pairing button for 3 seconds before releasing. The light on the front of the remote will flash periodically to confirm it is searching for the hub.
4. The light on the remote will remain solid for 10 seconds to confirm the pairing was successful.

Leaving the Zigbee Network

1. From the device's details page, select Remove Device, then Remove.
2. Remove the battery cover.
3. Press and hold the pairing button for 3 seconds before releasing.

AOne Smart Plug-In Socket

Product Number

Device Type

Protocol

AU-A1ZBPIAB

Socket

Zigbee

Factory Reset

1. Plugin the socket.
2. Press and hold the pairing button for 6 seconds before releasing.

Join the Zigbee Network

1. From the Hubitat Web Interface home page, select Zigbee on the Device Discovery page to start device discovery.
2. Press and hold the pairing button for 6 seconds before releasing. The light on the device will begin flashing.
3. The light on the smart socket will stop flashing when pairing is successful.

Leaving the Zigbee Network

1. From the device's details page, select Remove Device, then Remove.
2. Press and hold the pairing button for 6 seconds before releasing.

AOne Smart Double Socket

Product Number

Device Type

Protocol

AU-A1ZBDSS

Socket

Zigbee

Factory Reset

1. Press and hold the pairing button for 6 seconds before releasing.
2. Cycle mains power to the outlet.

Join the Zigbee Network

1. On initial power-up, the device will automatically enter pairing mode for 3 minutes.
2. Pairing is indicated by the LED light around the button flashing Blue quickly.
3. From the Hubitat Web Interface home page, select Zigbee on the Device Discovery page to start device discovery.

Leaving the Zigbee Network

1. From the device's details page, select Remove Device, then Remove.
2. Press and hold the pairing button for 6 seconds before releasing.
3. Cycle mains power to the outlet.