How to add and reset Ring products on Hubitat Elevation hub

Authored by: Support.com Tech Pro Team

1. Introduction

How to add and reset Ring products on Hubitat Elevation hub

2. Resolution

Factory Reset

1. Plugin the Range Extender.
2. Press and hold the button on the right side of the device. The LED on the device will flash rapidly.
3. When the LED begins to flash slowly, release the button.

Join the Z-Wave Network

1. From the Hubitat Web Interface home page, select Z-Wave on the Device Discovery page to start device discovery.
2. Press the button on the right side of the device to begin Inclusion in the Z-Wave network.

Leaving the Z-Wave Network

1. From the device's details page, select Remove Device, then Remove.
2. Press the button on the right side of the device to Exclude the device from the Z-Wave network.

Brand

Device

Product Number

Device Type

Protocol

Ring

Ring Alarm Range Extender v1

4AR1S70EN0

Repeater

Z-Wave Plus

Brand

Device

Product Number

Device Type

Protocol

Ring

Ring Alarm Contact Sensor v1

4SD1S70EN0

Contact Sensor

Z-Wave Plus

Factory Reset

1. Open the contact sensor cover.
2. Remove the battery from the device.
3. Press and hold the tamper switch while reinstalling the battery.
4. The LED will be flashing. Keep holding the tamper switch until the LED turns off.

Join the Z-Wave Network

1. From the Hubitat Web Interface home page, select Z-Wave on the Device Discovery page to start device discovery.
2. Open the contact sensor cover.
3. Quickly remove and replace the battery to begin Inclusion in the Z-Wave network.

Leaving the Z-Wave Network

1. From the device's details page, select Remove Device, then Remove.
2. Open the contact sensor cover.
3. Quickly remove and replace the battery to Exclude the device from the Z-Wave network.

Brand

Device

Product Number

Device Type

Protocol

Ring

Ring Alarm Motion Sensor v1

4SP1S70EN0

Motion Sensor

Z-Wave Plus

Factory Reset

1. Insert a straightened paper clip into the pinhole at the back of the motion detector.
2. Press and hold the reset button.
3. The LED will be flashing. Keep holding the reset button until the LED turns off.
4. Open the motion sensor cover.
5. Quickly remove and replace the battery to complete the factory reset of the device.

Join the Z-Wave Network

1. From the Hubitat Web Interface home page, select Z-Wave on the Device Discovery page to start device discovery.
2. Open the motion sensor cover.
3. Quickly remove and replace the battery to begin Inclusion in the Z-Wave network.

Leaving the Z-Wave Network

1. From the device's details page, select Remove Device, then Remove.
2. Open the motion sensor cover.
3. Quickly remove and replace the battery to Exclude the device from the Z-Wave network.

Brand

Device

Product Number

Device Type

Protocol

Ring

Ring Alarm Smoke/CO Listener

4SS1S80EN0

Smoke/CO Detector

Z-Wave Plus

Factory Reset

1. Press and hold the setup button on the side of the device for 10 seconds.
2. When the LED stops flashing, the device has been factory reset.

Join the Z-Wave Network

1. From the Hubitat Web Interface home page, select Z-Wave on the Device Discovery page to start device discovery.
2. Open the Smoke/CO Listener cover.
3. Quickly remove and replace the battery.
4. Press the setup button on the side of the device to begin Inclusion to the Z-Wave network.

Leaving the Z-Wave Network

1. From the device's details page, select Remove Device, then Remove.
2. Open the Smoke/CO Listener cover.
3. Quickly remove and replace the battery.
4. Press the setup button on the side of the device to Exclude it from the Z-Wave network.