How to add and reset WaterCop products on Hubitat Elevation hub

Authored by: Support.com Tech Pro Team

1. Introduction

How to add and reset WaterCop products on Hubitat Elevation hub

2. Resolution

Factory Reset

1. Press the Mode button once.
2. The status light will start flashing periodically (3-4 times) indicating the device has been reset and excluded from the Z-Wave network.

Join the Z-Wave Network

1. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Inclusion on the Device Discovery page.
2. Ensure that the status light is flashing periodically (3-4 times).
3. Press the Mode button once.
4. The status light will stop flashing upon inclusion into the Z-Wave network.

Exclusion from the Z-Wave Network

1. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Exclusion on the Device Discovery page.
2. Press the Mode button once.
3. The status light will start flashing periodically (3-4 times) indicating the device has been excluded from the Z-Wave network.

Device

Product Number

Device Type

Protocol

Emergency Water Shut-Off

WAT171021

Valve

Z-Wave